Skip to content

Unit: Commercial vinyl

LMFFL3302A: Install commercial vinyl floor coverings
LMFFL3303A: Install resilient floor coverings using custom designs and decorative finishes

Section 1: Commercial vinyl basics

Basic cutting and fitting


Image for slide 1
Audio for slide 1 (mp3 |6|KB)
The basic techniques used to cut and scribe resilient sheets are similar for all sheet products, including lay flat vinyl, commercial vinyl and linoleum.

We covered these principles in Lay flat vinyl, under the lessons shown below.

So in this lesson we'll look at the main differences that apply to commercial vinyl.

hearing icon
Image for slide 2
Audio for slide 2 (mp3 |6|KB)

Seams and joins

Commercial vinyl is thicker and tougher than lay flat vinyl, so you need to cut it in two passes of your knife - first with a straight or concave blade and then with a hook blade.

hearing icon
Image for slide 3
Audio for slide 3 (mp3 |6|KB)
With the first cut, keep the blade vertical so that it runs cleanly and safely along the straightedge.

Maintain an even pressure and cut to a depth of about halfway to two thirds.

With some materials you may need more than one pass to achieve this depth.

Then complete the cut with a hook blade.

If you want to make a bevel cut, such as when you're fitting to a wall, you can tilt the blade slightly.

hearing icon
Image for slide 4
Audio for slide 4 (mp3 |6|KB)

Using a recess scriber

When you get to the second sheet, you can mark it with a recess scriber instead of using the straightedge, if you prefer.

A recess scriber is also called an under and over scriber, or simply 'unders and overs'.

hearing icon
Image for slide 5
Audio for slide 5 (mp3 |6|KB)

The scribing procedure is as follows:

  • Set the 'over' scribe pin to the point where the 'under' guide will run along the true edge. You can test the setting at one end of the sheet nearest the wall and make adjustments if required.

  • Place the second sheet over the first sheet.

  • Scribe the top of the second sheet, keeping the 'under' firmly against the true edge of the first sheet.

  • Cut the scribed sheet using a straight blade and then a hook blade.

If the scribe mark is hard to see in the vinyl surface, you can rub it with chalk to highlight the line.

hearing icon


Learning activity

Audio 6 (mp3 |6|KB)

You'll remember from the Lay flat vinyl unit that we watched the Armstrong Floors 'Vinyl sheet installation video - Part 2' at:

Armstrong vinyl installation videos

The installer demonstrates how to use a recess scriber at 7 mins 35 seconds into this video.

Have a look at this little excerpt and then answer the following question:

  • What setting does the narrator recommend that you use between the over pin and the under guide?
hearing icon